I’ve had my XTX from day 1 and it has treated me super well but I noticed recently thee hotspot delta over edge temp was slowly increasing over the past months so I decided to finally disassemble, clean, and re-paste with some Kryonaut.
I don’t have any hard numbers from before (forgot to run a stress test and take notes) but purely from memory my edge temp is roughly the same (maybe 2-3°C decrease) but the hotspot dropped drastically by 18-20°C bringing it only 11°C delta over edge temp in a 10 minute furmark stress test. ( That is better than I EVER seen before on this card and I was definitely keeping an eye on it with the launch cards vapor chamber issues)
Looking at the old material, mine had developed a thin spot at the edge of the GCD and slightly over 2 of the MCDs
Personally found this interesting, figured some of the folk in here might make use of this information.
submitted by /u/DylanNoack
[link] [comments]
r/Amd I’ve had my XTX from day 1 and it has treated me super well but I noticed recently thee hotspot delta over edge temp was slowly increasing over the past months so I decided to finally disassemble, clean, and re-paste with some Kryonaut. I don’t have any hard numbers from before (forgot to run a stress test and take notes) but purely from memory my edge temp is roughly the same (maybe 2-3°C decrease) but the hotspot dropped drastically by 18-20°C bringing it only 11°C delta over edge temp in a 10 minute furmark stress test. ( That is better than I EVER seen before on this card and I was definitely keeping an eye on it with the launch cards vapor chamber issues) Looking at the old material, mine had developed a thin spot at the edge of the GCD and slightly over 2 of the MCDs Personally found this interesting, figured some of the folk in here might make use of this information. submitted by /u/DylanNoack [link] [comments]
I’ve had my XTX from day 1 and it has treated me super well but I noticed recently thee hotspot delta over edge temp was slowly increasing over the past months so I decided to finally disassemble, clean, and re-paste with some Kryonaut.
I don’t have any hard numbers from before (forgot to run a stress test and take notes) but purely from memory my edge temp is roughly the same (maybe 2-3°C decrease) but the hotspot dropped drastically by 18-20°C bringing it only 11°C delta over edge temp in a 10 minute furmark stress test. ( That is better than I EVER seen before on this card and I was definitely keeping an eye on it with the launch cards vapor chamber issues)
Looking at the old material, mine had developed a thin spot at the edge of the GCD and slightly over 2 of the MCDs
Personally found this interesting, figured some of the folk in here might make use of this information.
submitted by /u/DylanNoack
[link] [comments]